I've just discovered that the voltage rectifier (Rick's Motorsports) in my 89 FJ has fried. Replaced it earlier this year. Eithe...

Just flushed fresh rebuilt vfr800 and stock slave cylinder with dot 5. Got presssure, good pressure. Clutch can will not disenga...

Hi ,,Just asking if all FJ1200 Coils Packs are the same through out the years ,,Will Coils from a 1994 Model fit and run a 1986 ...

Hi all, I noticed some weeping from my clutch master a ways back, so i bought a MC rebuild kit from Randy, and put it in. Once i...

Another member found this decal that dresses up the ignition switch. http://www.diablocycle.com/Ignition-Switch-Decal.html Fred

Hi AllJust replaced front wheel bearings but when I knocked out the Speedo drive side out I didn't notice which way the clutch r...

I've been trying to sort out a problem with my 89 FJ. The engine runs well on startup, and for several miles runs great. Then it...

Installed a set of iridium spark plugs from RPM today.  This should be the last set of spark plugs I will ever need if they last...

I recently ordered, and used a master cylinder rebuild kit for my clutch from RPM. I put everything together, and now, after ble...

Hello All,I'm rebuilding my carbs for my 84' and i'm in the process of reassembling them. I went to install the emulsion tube to...

Hi All,What is the difference between the OEM disc rotors?Are they all the same and can the left be swapped with the right?I hav...

I've wondered about the feasibility of this in the past and due to my neglect have finally gotten the opportunity to try it out....

I ordered some new grips from Rev Zilla (sorry Randy, i didnt want foam haha), and they are gettinmg delivered today. So I went ...

Hi guys. I recently got a 92 fj1200 running I've had after a full carb rebuild, including new  diaphragms.  I have a high idle p...

Just installed new jets, needle and seat inside carbs after ultrasonic clean, now just filled them with fuel to check for leaks ...

So. I have leaking fork seals, but it has taken two years to have any real issues. I'm pretty sure I felt them bottom out as I a...

greetings to allI am the first time on this forumI apologize for my English, I'm from RussiaDo you need help, help with advice, ...

I'm new to the forum and I need help! I own a 87 fj1200 CA and I was having shifter issues. Took it apart and realized it was th...

I ordered a rebuild for my clutch master from randy a while back, and am just now getting to doing it. But as i got into it, i f...

So I was tracking down what I thought was an exhaust leak in my #3 header pipe. So I pulled all the header pipes off to clean th...