Maintenance

Pages: 1 ... 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 [148] 149 150 151 152 Go Down

	Subject	Started by		Replies	Views	Last post
0 Members and 14 Guests are viewing this board.
	carb problem(s) I have carb problems I can't seem to get corrected. I let it warm up and after you push the choke in the has no effect on the RP...		LA Mike	1	1439	November 27, 2009, 05:47:04 PM by Arnie
	Choke Cable I need to replace the choke cable on my '85 so I have everything off but trying to disconnect the cable from the choke lever. I'...		Tuxracer	7	2754	November 24, 2009, 08:22:19 PM by racerman_27410
	How to set headlights? FJ 1100 '84 uk spce My fj 1100 headlight too high. How to set headlight smoot down? Sorry I Knew Eng a little bit.		satanshow	2	1498	November 22, 2009, 11:56:56 AM by satanshow
	Tips and tricks for removing an FJ engine I have to do a full engine removal.Is there some info available and can anyone please post tricks & pitfalls clues and tips.Plea...		waricle	11	4482	November 21, 2009, 05:00:55 AM by threejagsteve
	Rubber grommets for side covers 84 FJ1100 Hi allIs there any place where one can aquire the rubber grommets that all the side covers are held on with.A few of mine are lo...		Gazz	9	4025	November 20, 2009, 09:59:00 PM by ren-dog
	Reusing valve shims Six of my valves are out of spec, too tight. Of the six, five were only .001 under spec, the sixth had only .002 clearance. The...		junkyardroad	5	4567	November 18, 2009, 09:26:00 PM by junkyardroad
	Wheel Trueness Has anyone checked the trueness of a number of wheels? GYSM says the limit is 2mm out. One I just checked is 0.8mm out; I'm wond...		threejagsteve	2	1529	November 11, 2009, 08:56:55 PM by threejagsteve
	What are the correct... « 1 2 » What are the correct bearing #'s for front and rear of a stock 1986 Fj1200? I would like to buy and have them here before taking...		europe50	17	4769	November 09, 2009, 04:05:10 PM by Pat Conlon
	Grips? « 1 2 » I was out for a short ride this afternoon, and it occurred to me that my original handgrips have gotten pretty bad - hard and wo...		threejagsteve	24	7461	November 05, 2009, 08:31:44 PM by threejagsteve
	FJ1100 LHS Crankseal Wonder if anyone knows if it is possible to replace the left hand side crankseal without splitting the engine. It's the one behi...		mtb001	4	1944	November 02, 2009, 10:03:10 AM by jvb_ca
	Fuel Pump Bypass?? Maybe possible? I am curious if I can keep a little piece of pipe or hose with barb fittings to bypass the fuel pump on long trips (in case it g...		capitanoinsano	13	4918	October 27, 2009, 04:30:49 PM by SlowOldGuy
	Has anyone used these seals? Has anyone used "EOK" valve seals? If so are you happy? Has anyone heard anything?Here's a link to some that sold recently:http:...		europe50	2	1783	October 24, 2009, 04:45:22 PM by Harvy
	Pilot jet vs. K&N filter? OK, I'm looking for opinions: I have a K&N replacement for the air stock filter. My FJ seems a touch lean at low rpm/low throt...		simi_ed	12	4198	October 21, 2009, 11:54:05 AM by andyb
	yet another tire thread. azaro vs sport demon vs roadriders « 1 2 » Has anyone tried Avon roadriders (am26) tires on their FJ? (mine is 1986, stock 16" rims) My azaro's need to be replaced, and wh...		uraberg	15	5936	October 12, 2009, 02:46:19 PM by threejagsteve
	Best carb sync sticks Anyone have a preference on them, I used to use the merc filled ones, worked very well, need to get a new set.		thuber3040	13	6408	October 12, 2009, 10:01:41 AM by Marsh White
	Collector replacement Changed my collector box today, why you say? Thanks Randy		jamesearthdrum	1	1572	October 11, 2009, 08:33:58 PM by rktmanfj
	I have the K&n pods... I have read some of the anti K&n comments, but how would it be if I add the uni outers over them, uni sells them just for that p...		thuber3040	3	2670	October 11, 2009, 04:35:48 AM by racerrad8
	Float height suggestion for 1986 Fj1200? Hey guys, I have a 1986 FJ1200 and want to set the best float height for my FJ. Due to the floats are old, has anyone noticed a ...		europe50	4	4401	October 08, 2009, 08:52:26 PM by andyb
	Carb Rebuild Kits Hey guys, sorry for the commercial but I owe some people a response to carb kit requests.To anyone that has requested a carb kit...		SlowOldGuy	12	4371	October 07, 2009, 06:02:20 AM by FJ Flyer
	Help: O-ring sizes???? Hey guys, I'm looking for the O-ring size for the fuel inlet "T" connection between the carbs? (T-shaped) Also, the O-ring size...		europe50	2	1557	October 05, 2009, 08:36:11 PM by FJmonkey

Pages: 1 ... 133 134 135 136 137 138 139 140 141 142 143 144 145 146 147 [148] 149 150 151 152 Go Up

Topic you have posted in

Normal Topic

Hot Topic (More than 15 replies)

Very Hot Topic (More than 25 replies)

Locked Topic

Sticky Topic

Poll

Jump to:

Your membership helps support the hosting costs of the forum
There are several levels of membership that offers other privileges.
Click here to see the various membership levels.