
Pages: [1] 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ... 124 Go Down |
|
Subject | Started by | Replies | Views | Last post ![]() |
|||
0 Members and 22 Guests are viewing this board. | |||||||
![]() |
![]() |
Clutch Replacement / Upgrade Time
« 1 2 3 »
First, I honestly tried the search tool, and I had no luck. Moving on - My FJ1200W's clutch has slipped a bit, and it's time to ...
|
FJ1200W | 35 | 8012 |
![]() by X-Ray |
|
![]() |
![]() |
Fuel injected fj12 looooooooong term project
I’ve been looking at the T Rex fj1200 race bike, bad move!Then, I pick up a free Fj! A very rough free fj.So, I started to chop ...
|
Pheasantplucker | 8 | 503 |
![]() by Pheasantplucker |
|
![]() |
![]() |
CBR1100XX Windscreen mod
« 1 2 3 »
I am thinking of shaping this windscreen to fit my 89'. Darran (oz.fj) has one fitted on his Blue and Gold 89' and IMO it looks ...
|
aviationfred | 33 | 11735 |
![]() by Firehawk068 |
|
![]() |
![]() |
Keihin FCR 39/41
« 1 2 »
Hi, I’m looking at installing a set of FCR’s on my 1314 FJ.Does anyone have any recommendations for jet sizes etc...Just pie in ...
|
s3dxm | 15 | 401 |
![]() by FJ1200W |
|
![]() |
![]() |
Thundercat wheel
« 1 2 »
.Hello, I am going to convert to a Thundercat rim and I cannot find some photos where the parts that had to be modified looked v...
|
Juanlamola | 15 | 490 |
![]() by fj1289 |
|
![]() |
![]() |
Buell Lowered Foot Pegs (wide version)
I really liked my Buell Lowered foot pegs that were on my '89. The only issue I had was..... They were very narrow and after mul...
|
aviationfred | 10 | 1141 |
![]() by big r |
|
![]() |
![]() |
Cheap Replacement for 88-90 Rear Shock
My life's too short to find any info through the search function so: Aside from aftermarket types, has anybody found a shock th...
|
woodcreekpete | 9 | 1544 |
![]() by FJ1200W |
|
![]() |
![]() |
Yzf750 swingarm mod
Tried to find more info through search but with no luck.
Anyone here did yzf750 swingarm coversion?
|
pajo99 | 13 | 721 |
![]() by Pat Conlon |
|
![]() |
![]() |
Fj1100 R1 suspension conversion??
Ok guys, so a couple months back I picked up an 2000 first gen r1 parts bike for 400 bucks! I harvested what I needed off the bi...
|
iridewheelies | 5 | 927 |
![]() by Russfjr1 |
|
![]() |
![]() |
GSXF Rear Brake Caliper amounting Bracket
Good morning everyone,I am switching out the rear wheel to the GSXR. Things are going fine. I don’t like the idea of keeping the...
|
RevDeal | 2 | 363 |
![]() by Ted Schefelbein |
|
![]() |
![]() |
90 motor in a 92
Greetings: Anybody ever swap an early model motor into a 91 or newer? The motor in my 92 seems to have not enjoyed running with...
|
woodcreekpete | 5 | 1159 |
![]() by woodcreekpete |
|
![]() |
![]() |
Variance in tire size
This subject has been mentioned before, but has not been cover in a few years.The subject is 180/55/17 rear tires installed on 1...
|
aviationfred | 1 | 382 |
![]() by Pat Conlon |
|
![]() |
![]() |
brake rotor upgrade
Hi, I want to upgrade to drilled stainless rotors and hi performance pads with braided brake lines on my 87 FJ1200. I am consid...
|
gregh | 11 | 1001 |
![]() by RPM - Robert |
|
![]() |
![]() |
Gear indicator the factory should have done
« 1 2 ... 5 6 »
I bought one of these from RPM... and bought some flat LED's... Four bright yellow, and one bright green. [img width=390 height=...
|
ZOA NOM | 79 | 17807 |
![]() by ZOA NOM |
|
![]() |
![]() |
84 fork shortning
« 1 2 »
Hi I am hoping some chaps out there may have some answers. I want to cut a couple of inches off a pair of 84 FJ fork tubes and h...
|
chiz | 24 | 1577 |
![]() by racerrad8 |
|
![]() |
![]() |
93 FJ rebuild project
Well, I haven't been around much lately. Last time I rode my '93 was three years ago. Since then it's been sitting covered in th...
|
Bob | 11 | 1548 |
![]() by Seanable |
|
![]() |
![]() |
Replace FJ1100 carbs or replace with XJR1300 carbs?
Quote from: FJSpringy on February 14, 2010, 02:36:17 PMwhen i was going through my carb gushing phase i extended the overflow tu...
|
nchattaway | 9 | 4701 |
![]() by tsak |
|
![]() |
![]() |
Fj11/Xjr12
So I've just dropped a set of Xjr1200 cylinders onto a set of Fj1100 crankcases and they dropped straight on.The crank case open...
|
Indiana jones | 3 | 434 |
![]() by Pat Conlon |
|
![]() |
![]() |
Any OEM carb choices for the FJ ?
Curious if anyone has had success fitting other ,larger, OEM type CV carbs ,,i think i read that FZ1 or maybe ZZR Kaw have bee...
|
turbocamino | 6 | 572 |
![]() by fj1289 |
|
![]() |
![]() |
MIKUNI RS38 flat slider carbs.
So, on this parts bike I bought, along with 5, or 6 totes of parts, is a set of Mikuni flat slider carbs. There is also the th...
|
Seanable | 13 | 1497 |
![]() by T Legg |
Pages: [1] 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 ... 124 Go Up |
|
![]() ![]() ![]() ![]() |
![]() ![]() ![]() |
Powered by SMF 1.1.10 :: SMF © 2006-2009, Simple Machines LLC
Your membership helps support the hosting costs of the forum |
|