
Pages: 1 [2] 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 ... 59 Go Down |
|
Subject | Started by | Replies | Views | Last post ![]() |
|||
0 Members and 8 Guests are viewing this board. | |||||||
![]() |
![]() |
1990 clutch has no pressure
« 1 2 »
Just moved and got my bike out of storage. About 50 miles into getting to my new house I noticed I was loosing pressure on the c...
|
vegetta58 | 20 | 1675 |
![]() by fj1289 |
|
![]() |
![]() |
Have to Give Up
« 1 2 »
Hello AllI've given up trying to make this bike run again. RPM went through the carbs but I spent months trying to figure out n...
|
AppleJack | 25 | 2558 |
![]() by andyoutandabout |
|
![]() |
![]() |
How to remove the rotor 8mm hex bolt froma dyna 2000 ignition
i tried the broom thing but it crushes the chain guard, and skrims, i have an impact battery drill, will that work?, it's on the...
|
mtc | 1 | 480 |
![]() by mtc |
|
![]() |
![]() |
does anyone know the size and type of fastener used to secure pickup coils 1985
« 1 2 »
i think is M6
but what is the length?
and head type
i could use cap screw right?
and is there a washer in there?
|
mtc | 15 | 2113 |
![]() by mtc |
|
![]() |
![]() |
Bike bogging down and stalling after 20 miles or so of riding
Hi All - my 1992 FJ1200 has been bogging down and stalling after about 20 or so mile ride. In order to get her back going,,, nee...
|
motozagogo | 4 | 872 |
![]() by FJmonkey |
|
![]() |
![]() |
sudden bottoming of stock fork springs 1985
i took em out to put .85 racetech, last year after i got the bike, never really rode the stock one other than riding it home, th...
|
mtc | 7 | 1065 |
![]() by mtc |
|
![]() |
![]() |
Wavy chickenstrips
I got back from a ride today and noticed my chickenstrips were wavy and fuzzy. I had heard that a misaligned tire could cause th...
|
T Legg | 5 | 1415 |
![]() by T Legg |
|
![]() |
![]() |
Loud backfire, engine quits.
« 1 2 »
Hello, everybody. After some months of maintenance and recovering from my leg, I run the bike last weekend. Nice weather here in...
|
Starquest | 26 | 5085 |
![]() by Starquest |
|
![]() |
![]() |
Vacuum line fuel issue..
So....here is a problem...Vacuum line coming off of intake on the #1 cylinder for the fuel petcock valve, seems to be either not...
|
dadofseven38 | 12 | 1669 |
![]() by Alexis Wenzel |
|
![]() |
![]() |
FJ1100 Won't Run
« 1 2 3 »
I'm fixing up my Dad's old FJ1100 that's been sitting since at least 2006. So far I've gotten the starter motor to work. My next...
|
SpazmaticAA | 38 | 5282 |
![]() by Dieselman7.3 |
|
![]() |
![]() |
hard shifting
Clutch disengages and engages ok as far as I can tell. Slave and M/C already rebuilt and bled.Bike is just a bitch to shift whe...
|
the_kirkwood | 10 | 1274 |
![]() by FJmonkey |
|
![]() |
![]() |
battery draining down
Morning from the uk. i have rebuilt my 1200 3cv and put a simple wiring system on it. not the first time ive done it and all was...
|
dirk | 0 | 400 |
![]() by dirk |
|
![]() |
![]() |
not charging
I think my alternator is bad battery voltage is not increasing when i rev engine I checked alternator brushes and they are good,...
|
rollinghelmet | 8 | 1508 |
![]() by rollinghelmet |
|
![]() |
![]() |
Clutch Won't disengage
OK, so this is likely something I caused. In fact, I have no doubt.Clutch was working before I touched it!So, I replaced the OEM...
|
the_kirkwood | 9 | 2232 |
![]() by the_kirkwood |
|
![]() |
![]() |
1986-88 1TX overheating
« 1 2 »
Hi guysMy 1TX is finished and working fantastically after a top end refreshing process. Even in the running in period I can feel...
|
Alf | 23 | 2708 |
![]() by Alf |
|
![]() |
![]() |
She wants to idle at 2000 rpm after good and warm.
For the first 15 minutes or so it runs fine, but then it kinda defaults to a 2000 rpm idle. Sometimes I can control it by slippi...
|
domonkos49 | 1 | 525 |
![]() by FJ_Hooligan |
|
![]() |
![]() |
Carb Fuel Leak
Hi All,I've had a fuel leak from my carb from day 1 on my '91 fuel pump 3XW, so I decided to buy a rebuild kit and clean them. A...
|
FJ12IRL | 13 | 1793 |
![]() by fj1289 |
|
![]() |
![]() |
Stater chain getting stuck
« 1 2 »
Hello fellow FJ owners,Recently my 84 FJ occasionally lock up when starting. It will fire the first cylinder with a puff of smok...
|
Greenlander | 15 | 2279 |
![]() by Klavdy |
|
![]() |
![]() |
I solved my intermittent headlight problem
I have had an intermittent headlight problem. It first happened to me last september .After checking the fuse it began working a...
|
T Legg | 6 | 1085 |
![]() by Miker |
|
![]() |
![]() |
I could really do with some advice please.......
« 1 2 3 »
Hello all. I'm new to this forum and have recently come to own a 1991 FJ1200 3XW. I have previously owned other bikes such as a ...
|
flo3flo | 40 | 5746 |
![]() by iWant2RideMyBike |
Pages: 1 [2] 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 ... 59 Go Up |
|
![]() ![]() ![]() ![]() |
![]() ![]() ![]() |
Powered by SMF 1.1.10 :: SMF © 2006-2009, Simple Machines LLC
Your membership helps support the hosting costs of the forum |
|