
Pages: 1 2 3 4 5 6 7 8 9 10 [11] 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 ... 59 Go Down |
|
Subject | Started by | Replies | Views | Last post ![]() |
|||
0 Members and 14 Guests are viewing this board. | |||||||
![]() |
![]() |
No power under 7000rpm
The engine ran well, but after i replaced the carb diaphragms (jbm) and exhausts there is no power below around 7000rpm.After 70...
|
Fj1200buggy | 10 | 4451 |
![]() by Pat Conlon |
|
![]() |
![]() |
2nd Ignitor Box in 5 Years?
Just sharing an issue i had with my FJ1200 3CV after a good week of fault diagnosis i concluded the IGNITOR Box was the only pos...
|
Seanextra | 9 | 5218 |
![]() by Pat Conlon |
|
![]() |
![]() |
92 FJ1200 Clutch
« 1 2 »
Hi All, Just rebuilt and bled the clutch master cyl. and slave cyl. and clutch won't disengage. Removed slave and pulled in clu...
|
PGH STEEL 66 | 20 | 8206 |
![]() by PGH STEEL 66 |
|
![]() |
![]() |
Battery issues
Ive read a few posts about battery/charging issues. I just got me a 1986 FJ1200. Its pretty rough. But it runs. Sometimes. It ha...
|
EGDarrow | 5 | 2304 |
![]() by FJmonkey |
|
![]() |
![]() |
Re--aligning front end
Hi after removing forks,mudguard,wheel etc from my FJ12 3xw and replacing them the front wheel seems of line ,as when riding it ...
|
scotiafj | 1 | 2216 |
![]() by Bones |
|
![]() |
![]() |
tracking down an electrical issue
Had Randy hot/cold test my pickup coil. that tested out fine. he suggested the on/off switch needs cleaning, so that is next.I ...
|
bigbore2 | 13 | 5727 |
![]() by bigbore2 |
|
![]() |
![]() |
Clutch slipping after rear wheel swap
Happy with handling after rear wheel slip.Took bike on a sunday afternoon trip off about 150km to test it through some curves.On...
|
aj52 | 8 | 3710 |
![]() by JOMPPA10 |
|
![]() |
![]() |
Yesterday happy today not happy valve adjustments =)
« 1 2 »
So yesterday i finally got my bike running after valveadjustment and some carbtrouble.It did run smooth quiter and seemed to hav...
|
Old Rider | 20 | 13154 |
![]() by fnlyafjat51 |
|
![]() |
![]() |
1tx CDI wiring help needed.
I'm sorry it's a want guys, I have been lurking around the forum for a while. I'm at henpoint ofnwiring up. Y bike using the mot...
|
Hath87 | 2 | 1953 |
![]() by Hath87 |
|
![]() |
![]() |
Early Blue Spot Issue!
'94 Blue Spot Servicing. Heeeelllppp.Well I was hoping to have the '94 ready for our Mapleton Muster, but it wasn't to be. Had a...
|
X-Ray | 1 | 1824 |
![]() by X-Ray |
|
![]() |
![]() |
Running Diagnosis
« 1 2 »
I All. I know there would be a solution to my running issues on the forum somewhere, but I am having trouble finding it.So here ...
|
Urban_Legend | 16 | 6827 |
![]() by bigbore2 |
|
![]() |
![]() |
Compression Values
Doing a compression test on a 88 FJ1200 returned values of between 80-90psi which seems a little low for my tasteTest was done c...
|
Paris | 2 | 2635 |
![]() by Paris |
|
![]() |
![]() |
Carb Tuning, Why it's so hard for me?
Ok Fellas, I don't care who thinks that me as a dumbass but I could not get the idea and make the mixture well.. maybe tried ti...
|
tderida | 6 | 4077 |
![]() by bigbore2 |
|
![]() |
![]() |
Carb Headache
« 1 2 »
So now that iv got the electrics sorted (thanks to a cleaver tip on this forum) iv run into another problem.My '88 FJ1200 wont r...
|
Paris | 16 | 4965 |
![]() by Paris |
|
![]() |
![]() |
Suspect a misfire...
So I'm back to my 92 FJ after over a year of being out of the country. I was riding the other day, and as I was pulling into the...
|
LtPwnzor | 5 | 3404 |
![]() by Russfjr1 |
|
![]() |
![]() |
Power but no start
Hey guysI have a 1988 (ish) FJ1200 that is not starting, Easiest way to describe the fault is it is like trying to start it with...
|
Paris | 11 | 5440 |
![]() by Firehawk068 |
|
![]() |
![]() |
Electrical (or maybe not) problems
« 1 2 ... 7 8 »
hey guys. i could need some ideas. i started working on the fj1100 i bought last week and was wondering if anyone here have any ...
|
element303 | 112 | 40953 |
![]() by Earl Svorks |
|
![]() |
![]() |
Valves then carbs not the other way....
So here is the story in a nutshell.Nimbus helped me purchase a 91 FJ1200(Beautiful shape)60,000 km on the odometer and engine lo...
|
Mr. Grumpy | 2 | 3018 |
![]() by tderida |
|
![]() |
![]() |
Help not starting after fast carbclean and inntakerubber replacement.
I have a 86 fj1200 1tx .Bike did run before i started working on it ,but it did misfire a little and did get hot.I hawe replaced...
|
Old Rider | 6 | 2971 |
![]() by Old Rider |
|
![]() |
![]() |
Gauges driving me nuts
« 1 2 »
Not a single gauge works on my 91 1200. It lights up but nothing moves. Any ideas where to look?
|
barberman91 | 23 | 10594 |
![]() by ct7088 |
Pages: 1 2 3 4 5 6 7 8 9 10 [11] 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 ... 59 Go Up |
|
![]() ![]() ![]() ![]() |
![]() ![]() ![]() |
Powered by SMF 1.1.10 :: SMF © 2006-2009, Simple Machines LLC
Your membership helps support the hosting costs of the forum |
|